REJEX ON BLACK CAR FREE

RejeX is not meant to be used on porous surfaces, highly oxidized painted surfaces, or to fill fine scratches. REJEX PROTECTS AND BEAUTIFIES PAINTED METAL, GLASS, ACRYLIC, GEL COAT, FIBERGLASS, GLOSSY PLASTIC & POLISHED METAL SURFACES before it has cured, the contaminants may interfere with or embed in the protective film. If the coating is exposed to contaminants such as oil, fuel, soot, hard water, tree sap, cleaners, etc. It is important to allow RejeX to cure for 8-12 hours after the haze has been wiped off. Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to cross-link into a crystal-clear, impervious film. RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 8-12 hours (depending on the humidity the higher the humidity, the faster the cure). If the surface is too hot, the coating can cure before it has properly bonded to the surface, so it may not perform up to its potential. When over 85° F, be sure to apply RejeX out of direct sunlight. Ideally, RejeX should be applied to a cool, dry, clean surface.

REJEX ON BLACK CAR FREE

RejeX contains none of the free silicone oils found in some other products that are known to contaminate paint and cause problems when repainting. It’s easy to apply and produces a deep, lustrous shine that outlasts the most popular waxes by months. It also makes graffiti easy to remove and can be applied to windshields to repel rain. This very thin film – less than a micron thick – prevents stains and adhesion of common contaminants such as exhaust, bugs, oil, tree sap, bird droppings, road grime, brake dust, etc. RejeX® is a thin-film polymer coating designed to provide a high-release protective finish for vehicles of all kinds.

SPACE AGE PROTECTION FOR YOUR CAR, TRUCK, BOAT, RV, AIRPLANE & MOTORCYCLE

Rejex on black car